Head Hand Shower / Sink Faucet Combo - Repair or Replace?

[JimFromMD]

Hi All,
Have a combo head sink faucet / hand shower that has started dripping. Has anyone repaired these or have an installation manual? Typically at home you can take the faucet apart and replace the or rings or other parts inside to stop the drip.

I didn't have much time when we got back to the marina to look at how this one may come apart. I think the drip issue is in the on/off knobs vs the hand shower itself. Didn't see any set-screws or anything that would allow me to take the knobs off.

Looks like it's a Scandvik fixture similar to the one below. Hoping there is a way to repair vs complete replacement.

Thanks
James

 

[DaveOB]

I have the same issue with mine. No visible means to remove on/off knob to replace cartridge. I'll be watching to see if anyone has solution, too.

 

[JimFromMD]

According to Sea Ray, it was made by ITC marine (itc-marine.com). Their part number was 98656B-CP-W. ITC is researching the connections for me (since I'm not at the boat to look) but do not have any of the parts or entire units in stock.

Sea Ray recommended a part like they have in the 2012 280 DA (part number 2017380) which is a single lever style unit with pull out shower head. He seemed to think that I'd need to cover the original sets of holes (meaning more than one) then install the new single-hole model. From what I remember there should only be one hole in the counter top the way my faucet looks (or so I hope)...

Any chance you are nearby your boat that you could stop and look? I wont have chance until the weekend.


They also recommended getting something from FP or great lakes skipper if we wanted something similar to the current unit.