Russ Calasant
Active Member
i have a 12.5 Westerbeke that was blowing the fuse at start up on the control panel at the gen. It proved to be two sensors, water/temp and one of the oil switches. After putting everything back together the alarm on the systems monitor now sounds immediately upon starting (cold). Temp gets to 180 / 185 with a load, good flow and the oil pressure is 49psi- according to the panel. I let her run 15-20 minutes with no change and constant ringing of the alarm. I tried jumping all three sensors individually with no difference. Anyone have any ideas? I cannot figure it out.