Fresh Water System on 2011 Sea Ray 220 Sundeck

[Jeff Copeland]

Looking for someone with a similar 220 Sundeck that has the freshwater tank, pump, and transom shower.

My boat apparently did not come with the freshwater system option from the factory. However, it has the helm switch for the water pump, so I'm trying to figure out if the freshwater tank and/or wiring for the pump is already there.

I'm hoping someone with a similar boat that has the factory freshwater tank and pump can show me some pics of where these are actually located when installed by the factory.

I know the 5-gal freshwater tank is supposed to be under the port aft ski locker, but I'm not sure if it would be under the deck of the ski locker, or it if literally sits inside the ski locker and takes up space?

If it's under the deck of the ski locker, would it have been installed on every hull, even if the option apparently wasn't selected on this boat? I do see a small (1"?) plastic plug on the deck of the ski locker (which is molded fiberglass with no apparent access panel), but I haven't removed it yet to see what's underneath.

I'm also trying to figure out where the wiring/connector for the freshwater pump is located, what it looks like, and whether I have it on my boat. I have a couple of unused 2-pin plugs in the vicinity of where the pump would mount (haven't tried a voltmeter yet to see if either is connected to the water pump switch).

I realize I could install all aftermarket stuff and put it anywhere. I'm just trying to figure out where the factory install would have gone, and how much of the system is already there on my boat.

Thanks!

 

[Lazy Daze]

None of the hard parts will be pre-installed. It will not be glassed in underneath a fiberglass deck. It will be accessible.

Pre-installed wire harness: Easiest way to tell is to look at the coded data on the wire connectors you found and compare that to the data noted in your electrical wiring diagram. All wires are data coded by Sea Ray to match up with the electrical diagrams. But, running the wires is not really all that hard, if you have to. Is there a power wire leaving the correct fuse spot in the fuse panel?