Xplicitlnck
Well-Known Member
Well here we go again. Another week another problem. On my boat the entire cockpit floor raises to gain acces to the er. The floor is raised by 2 hydraulic rames. One port one starboard. When lowering the floor the port side always came down just a little faster. Mayb closed about 2 inches before starboard side. Both rams are on one switch so the only option was to hold the switch and wait for the other side to close. While doing this the port ram stopped working.no up no down. Are both rams run off the same fuse? Relay? This rarely happens but im at a complete loose in were to even start fixing this.. I don't think I can even get it out with the floor down. Theres so much pressure on the clevit pin holding the ram to the underside of the floor I cant move it... any ideas?