Coldseize
New Member
I am going to put my engine back in soon and the bolts I took out where bent and oblonged the holes. The wood and glass are solid but not sure what the correct way of doing this is.
a) Fill the holes in with resin and redrill.
b) Turn the mounts and drill new holes.
c) Fill in the old hole and move to fresh wood/glass.
d) Duct tape and tie wraps.
Thanks Jeff
a) Fill the holes in with resin and redrill.
b) Turn the mounts and drill new holes.
c) Fill in the old hole and move to fresh wood/glass.
d) Duct tape and tie wraps.
Thanks Jeff