Cruisair problem

[Almirante]

Hi,
does someone know where to find the trigger switches of the AC on a´97 450 Sundancer?

Thank you,

Stefan:smt100

 

[The Bill Collector]

Stefan, what is the "trigger switch" ?

 

[Almirante]

Stefan, what is the "trigger switch" ?

I read about " trigger switch" here in the forum, when talking about a similar problem on another Searay with Cruisair. "Relais" is another word, I know for it.
It is the part that decides, or activates the pump, when your AC is standby/running.

Hope I made it clear now...:smt024

Stefan

 

[ktcanuck]

I think you will find them in the pump relay box.

 

[fwebster]

The pump relay box is under the salon couch near the salon AC unit......look for about a 5"X7" white junction box. looks like this:

http://www.ebay.com/itm/like/181714660401?lpid=82&chn=ps

I don't know who this seller is; his ebay listing is just the first photo that popped up on a search.

 

[Almirante]

The pump relay box is under the salon couch near the salon AC unit......look for about a 5"X7" white junction box. looks like this:

http://www.ebay.com/itm/like/181714660401?lpid=82&chn=ps

I don't know who this seller is; his ebay listing is just the first photo that popped up on a search.

Thank you, Frank. Found the box. We will check it at the weekend.

Stefan

 

[Alegria]

Stefan,

I think I have a similar vintage unit. There are two gray wires going into that box. One is for the temp sensor and the other if for the control pad. Push them in gently as they might be loose. I had one loose on the control panel cable. It would flicker and not respond, found the box and found one gray wire to be loose. Reset it and all was well. Fingers crossed that your temp sensor is loose and that is preventing your unit from kicking into cool/heat mode....

Take Care!!

 

[Almirante]

Stefan,

I think I have a similar vintage unit. There are two gray wires going into that box. One is for the temp sensor and the other if for the control pad. Push them in gently as they might be loose. I had one loose on the control panel cable. It would flicker and not respond, found the box and found one gray wire to be loose. Reset it and all was well. Fingers crossed that your temp sensor is loose and that is preventing your unit from kicking into cool/heat mode....

Take Care!!

Checked the complete thing again. Took out the bridge. Measured the electrical connections, tested....and everything worked again, business as usual.:smt001
So it could have been a loose connection.

Stefan