Pony Racer
Member
shake down run went as expected.. everything ran great, nothing major to report..
she is in her home port ran into 1 little annoying issue..
but also have "how to i add" questions..
1.. the Smart craft display while showing the rudder position will "bounce all over the place" only while Starboard engine is IDLING and warm(ie docking after a trip).. i can use the rudder position on the autopilot to center them so for now thats what im doing..
underway its fine... port engine only idleing (fine) both engines underway (fine) first started when cold starboard (fine) after a run and docking is the only time the issue pops up.. or if i just started begin underway only at idle this issue will persist b ut disappear as soon as she is above 1200 rpms.. dont know where to start diagnosing this one.. :huh:
2. what do i need to integrate my Raymarine C125 to the smart craft system there is a window for it..
3 what is needed for C125 for depth/fishfinder?
4. what is needed for the c125 to control the St7001 Autopilot?
she is in her home port ran into 1 little annoying issue..
but also have "how to i add" questions..
1.. the Smart craft display while showing the rudder position will "bounce all over the place" only while Starboard engine is IDLING and warm(ie docking after a trip).. i can use the rudder position on the autopilot to center them so for now thats what im doing..
underway its fine... port engine only idleing (fine) both engines underway (fine) first started when cold starboard (fine) after a run and docking is the only time the issue pops up.. or if i just started begin underway only at idle this issue will persist b ut disappear as soon as she is above 1200 rpms.. dont know where to start diagnosing this one.. :huh:
2. what do i need to integrate my Raymarine C125 to the smart craft system there is a window for it..
3 what is needed for C125 for depth/fishfinder?
4. what is needed for the c125 to control the St7001 Autopilot?
Last edited: