Cabin Table Dimensions

[scootdogg]

does anyone know the cabin table dimensions? i am considering having a custom mahogany table built with inlays and need those dimensions. i am 3 hours from the boat so i cant just run down to it!

thanks!

 

[Nehalennia]

Cabin or Cockpit?

 

[scootdogg]

cabin please.

 

[jason78]

cabin please.

Which one? The dinette table or the V-Berth table?

 

[scootdogg]

the dinette

 

[jason78]

the dinette

OK, I will be at the boat Sunday so will get the dimensions then but someone will probably post them sooner.

 

[scootdogg]

OK, I will be at the boat Sunday so will get the dimensions then but someone will probably post them sooner.

that would be awesome! thanks so much in advance!!

 

[Henry Boyd]

From our 2002

Fore <-> Aft = 27"
Aft port<-> stbd width = 31 5/8"
Fore port<->stbd width = 29 1/4"

Corner radius appears to be 3" (that's what I used when I re did mine)
edge radius 1/4"
thickness = 1" If you plan to use the dinette 'berth' you want to maintain about the same thickness

angle forward port side corner 5 degrees

Henry

 

[Streiten]

Hi, Are either of you aware if there is a proper way to remove the cockpit table on a 1999 270 Sundancer? It may seem like a silly question, however I'm a new owner and can't seem to locate any instructions. It's not round, more rectangle and takes up quite a bit of room. I thought I better ask, it's better than damaging something? Any advice would be appreciated!
Bill

 

[Bridog]

There shouldn't be anything keeping it in. Sometimes they need a little extra "elbow grease" Twist and pull up. Watch your chin

 

[Streiten]

Thanks so much! It won't damage anything if I twist it some? I bet it's been in there for quite some time.

Thanks again!

Bill

 

[Henry Boyd]

You can also try tapping the leg with a rubber mallet down close to the base. The leg is tapered slightly and over time it gets jammed in the socket.

Henry

 

[Streiten]

Thanks again, I'll give that a try!

Take care,

Bill