Bravo III 24P Props

[mrcoolgli]

I have two stainless steel props. I pulled them off my single engine Sundancer 290 because the wholeshot was way to bad. I would like to get 750.00 for them. I am in North Texas. I can provide pictures. They are flawless.

 

[mrcoolgli]

Feel free to make me an offer. I have pictures, I tried to upload them however it won't allow me to upload a 60K image..

 

[Clam Bake]

I currently have 24P, so I do not want to buy these - but I am curious what pitch you replaced them with? If I look at the Sea Ray prop chart it says I should have 26P. The previous owner must have swapped them on my boat? I am considering purchasing 26P. Any idea if I change from 24P to 26P would my WOT RPM's go higher or lower then they are now?

Thanks, Pete.

 

[Loneranger]

Good luck with finding a buyer. I have been trying unsuccessfully to sell my 24p set for $500 and have yet to find a buyer although I have not looked really hard.

John

 

[Nehalennia]

Pete , what is your WOT now?

 

[mrcoolgli]

I went to 20P props with my 1994 290 Sundancer. It's a single engine 454, its brand new last year. We were having a hard time getting it to come up out of the hole with four adults, full freshwater and full gas tank. It would take close to 45 seconds to plane out. Top speed was good once it finally got up there, around 40 mph. My RPM's were a little low though. Right at 3800-3900 rpm. So I swapped out to 20P.. My hole shot is awesome, can pull skiers out of the water no problem. I lost the 40mph top end, it's only about 30 mph at most now. But at WOT I am sitting at 4200 ~ 4300 RPM. For us it was the right move. I suppose I could keep them in case I ever needed to swap them out for some reason...

 

[No Name Sea Ray]

Pete if you go up in pitch- 24 to 26, then you rpms will go down about 300-400 rpm per 2" of pitch change.

Go here for a little education- http://www.propmd.com/t-PropellerBasics.aspx

Ben at Prop MD was very helpful in finding the best prop size and in buying my used ones.
www.propmd.com