Bow led light for 03 240

[03_240]

I am in the process of converting to LED's I have all of the lights in route except the bow light.

I can not find a replacement part number for the bow light. I would like to replace the entire assembly rather than change the bulb.

thanks for the info!

 

[BOEMARINEBRIAN]

Have a look here! https://boemarine.ecomm-nav.com/search?q=led+navigation+light&x=0&y=0

 

[jason78]

This is going to be the closest to your factory light footprint. As I recall the 240 has a single Attwood NAV light up front. I think you are making a wise choice replacing the entire assembly. http://www.amazon.com/Attwood-2-Mile-Mount-Navigation-Stainless/dp/B01606WMVM

 

[03_240]

that is the exact part i have been looking at jason78, from the original information I can find it is an attwood. I am hoping the footprint or at least the mounting holes are close. Has anyone done the conversion?

 

[jason78]

that is the exact part i have been looking at jason78, from the original information I can find it is an attwood. I am hoping the footprint or at least the mounting holes are close. Has anyone done the conversion?

My 280 had the separate Red/Green side markers. Essentially the same fixture you have but with a single light lens on each side. The light I posted the link to is the closest you will find to the same footprint of the original Attwood light on your boat. The screw holes do not line up but the wire hole should line up fine. I have replaced about 8 of the old Attwood incandescent fixtures with the newer LED in the link and all have worked fine but you will need to drill new screw holes. Just make sure you use plenty of sealant in the wire hole, old screw holes and new screw holes. I recommend 3M 4000UV since this is deck hardware. You could also use Marine Silicone as an alternative. Do not use 4200 or 5200 for this install.

Like I said I have used these Attwood LED lights a number of times for myself and friends and I am very satisfied with them. Make sure you get the 2nm rated fixture for the brighter output. Also, make sure the center of the fixture is parallel with the center-line of the boat to it points straight ahead.

 

[BOEMARINEBRIAN]

http://www.boemarine.com/attwood-35...-red-green-combo-12v-stainless-steel-housing/

 

[jason78]

Sorry Brian, should have checked BOE first. Looks like you guys are widening your range of items. Always have been happy with electronics I got from you!