Greetings all,
Earlier, I posted a question regarding power wiring for new stereo system, and got great feedback. I've now got a better handle on the system I want to run, but am not sure If I'm asking too much of the electrical system. So.... 2 - Alpine pdx-5, 5 channel amps that are rated at 75 X 4 + 300watts mono. One of these will drive 2- 6.5's in the berth, and 2- 6.5's in the salon, also, I plan to drive 1- 5.25" subs in each of these two compartments. The second of these power the 4-6.5's outside along with 2-10" subs. The amps are fused for 80 amps. I dont expect to ever run this rig at full tilt, but I cannot seem to find anyone who can give me a reasonable continuous amp draw rating. My power scheme is to run 1/0 gage for power and grd from the house batteries protected by a 100-125 amp fuse, then to a fused distribution block, then 4 ga to the amps.
Any/All thoughts welcomed.
Earlier, I posted a question regarding power wiring for new stereo system, and got great feedback. I've now got a better handle on the system I want to run, but am not sure If I'm asking too much of the electrical system. So.... 2 - Alpine pdx-5, 5 channel amps that are rated at 75 X 4 + 300watts mono. One of these will drive 2- 6.5's in the berth, and 2- 6.5's in the salon, also, I plan to drive 1- 5.25" subs in each of these two compartments. The second of these power the 4-6.5's outside along with 2-10" subs. The amps are fused for 80 amps. I dont expect to ever run this rig at full tilt, but I cannot seem to find anyone who can give me a reasonable continuous amp draw rating. My power scheme is to run 1/0 gage for power and grd from the house batteries protected by a 100-125 amp fuse, then to a fused distribution block, then 4 ga to the amps.
Any/All thoughts welcomed.