Hi guys, I want to tighten (or at least check torque) on the cinch bolts that hold the steering pin in place. I know this is a wear item if not serviced, my question is where exactly are those nuts to torque? Are they the two on the outside of the boat on the gimbal ring, or on the inside of the transom?
I was able to find torque specs of 50ft/lbs but unable to find the location of the bolts in the service manual I have. The PDF of the manual isn't searchable, so it is a pain to find stuff
Thanks
I was able to find torque specs of 50ft/lbs but unable to find the location of the bolts in the service manual I have. The PDF of the manual isn't searchable, so it is a pain to find stuff
Thanks