boatman37
Well-Known Member
- Jun 6, 2015
- 4,256
- Boat Info
- 2006 Crownline 250CR. 5.7 Merc BIII
Previous: 1986 Sea Ray 250 Sundancer. 260 Merc Alpha 1 Gen 1
- Engines
- 5.7 Merc BIII
wanting to install my hour meter in my dash (1986 Dancer). my old hour meter was back by the engine. anyone ever cut holes in the dash on these? what did you use? i'm afraid of cracking or ruining the original. i plan to do a test fit on a piece of acrylic or something. the new meter has a square mounting area. the gauge face is round but the hole can be either about a 1 7/8 circle or i can make it about a 1.75x1.75 square. either way, what can i cut this with for best reaults. not planning to remove it so hand cutting will likely be used.