99 Sundancer DA mounting of cockpit cushions

[Stocksj]

Hi, I'm sure this has been covered but I'm in a bit of a rush. I need to know how the cockpit cushions on a 290 DA are mounted. I have the port lounge cushion and the rear seat cushions coming loose and I need to know how to remove them and re-attach them properly. The port cushion had been redone by the previous owner but it looks like it was attached with silicon glue and isa coming loose. Same for the stern seat cushion. How are these mounted and removed so I can do it right?

Thanks

99 Sundancer 290
Sunny III
Ruskin, FL

 

[Strecker25]

Hi, I'm sure this has been covered but I'm in a bit of a rush. I need to know how the cockpit cushions on a 290 DA are mounted. I have the port lounge cushion and the rear seat cushions coming loose and I need to know how to remove them and re-attach them properly. The port cushion had been redone by the previous owner but it looks like it was attached with silicon glue and isa coming loose. Same for the stern seat cushion. How are these mounted and removed so I can do it right?

Thanks

99 Sundancer 290
Sunny III
Ruskin, FL

Port lounger is likely through bolted (screwed, really. But same idea) You have to remove the panels inside the aft cabin to get to the screw heads. It may be held with industrial velco (think the stuff that holds EZ pass to your windshield) but I think they only did that at some factories on certain years.

For the stern, which seat cushion? Are you talking about the far back bench seat? That ones just held on with snaps and comes out easily.

 

[B.matt]

I thought my lounger cushion on my 260 was bolted also. Was about to rip the cabin apart and my sister pulled it off. Velcro