44 2008 sb screen door

[Labbur]

44 2008 db screen door

How do I remove screen door to salon area. I need to replace the screen

 

[Bugsy24]

The first thing you don't do is "Double Post"! The second thing you should do is "Support the Site" (see the little metallic icon next to most peoples names)! I'm going to assume it's just like a normal slider, it's got wheels that are spring loaded either on the top or the bottom. Find the wheels, get a small Flathead in there and pop the wheel out of the Track!

 

[Labbur]

I am trying to delete one of the posts and the option under edit does not let me accomplish the task. Will ask the adm to delete.

 

[Labbur]

Another note on this. I am able to pop the rollers up but the door frame would not allow removal.

 

[ddietz]

Since the screen door is inside the sliding door, you have to take out the glass doors off first to make room to remove the screen door. Remove the plastic piece in the top of the frame so you can lift the movable section of the door. Tilt and remove. Then remove the screws holding the fixed side of the door, remove the door by lifting and tilting out. The door is heavy, so be careful. Once the door is out you can get the screen door off. It's not too hard, just a lot of screws. You have to reinstall the screen door the same way.

 

[Labbur]

Thank you so much for your help

 

[sb in gp]

Since the screen door is inside the sliding door, you have to take out the glass doors off first to make room to remove the screen door. Remove the plastic piece in the top of the frame so you can lift the movable section of the door. Tilt and remove. Then remove the screws holding the fixed side of the door, remove the door by lifting and tilting out. The door is heavy, so be careful. Once the door is out you can get the screen door off. It's not too hard, just a lot of screws. You have to reinstall the screen door the same way.

So I'm trying to do the same on a 44db. The fixed door will not come free because of a guide post that is under the track. Any other ideas. Hate to take the whole frame off.

 

[sb in gp]

Figure out a way to get both doors off. Had to use the dremel to cut a small notch in the port side of the bottom of the stationary door so that it would pass over the guide in the track. Here are some pics.

Sent from my iPhone using Tapatalk