390DA depth gauge not working

[almostenuff]

My boat has been sitting in the river without much movement for the last three weeks and when I went to take it out today the depth gauge showed nothing but –-- I pulled the transducer out and cleaned off the crud, but still nothing. Other than pulling it out and listening for clicks does anyone else have any troubleshooting tips?

 

[Dasch Boat]

Went through the same thing back in early July, found a replacement on eBay for half of what MM was asking

 

[almostenuff]

Went through the same thing back in early July, found a replacement on eBay for half of what MM was asking

Do you remember brand, seller, 200khz or 235khz? I'm pretty sure that it's a P17

 

[Dasch Boat]

Do you remember brand, seller, 200khz or 235khz? I'm pretty sure that it's a P17

Like I said in your other thread you have a diesel and I have a gasser so they may not be the same so I would cross check the part number. Mine is Mercruiser part# 888828A13

 

[almostenuff]

Like I said in your other thread you have a diesel and I have a gasser so they may not be the same so I would cross check the part number. Mine is Mercruiser part# 888828A13

I found a 888828 on eBay. Not sure if that'll work or not. Let's just hope mine is disconnected. I should know tomorrow. Thanks again