260 Sundancer V-berth Table

[estebanj]

There are two boards that provide support for the table when in bed configuration. Each board has a notch, but I can't tell what it's for. Any ideas?

Also, where is the designated storage for the filler cushions? Is it the hanging locker?

Thanks,

Esteban

 

[thunderbird1]

What year is your 260? In our 2006 there is only one support when the table is configured as part of the bed. The designated storage is the hanging closet, but we keep ours in the mid-berth.

 

[lorenbennett]

On ours the cushions go back to the walls and bed becomes table or slides foward under everything. :thumbsup:

 

[jg300da]

The two notches are for a cross piece that fits into them and supports the bottom of the table/filler. That piece should be in the hanging locker or beneath one of the seat cushions.

 

[Dave S]

As far as I know there is only one notch in each side support and there should be a board that fits into that notch to support the front of the table when it is lowered and used to support the center cushion. Our center cushion and the support board were both in the locker when our boat was delivered as well and that's where we store them.

 

[estebanj]

I think I'm missing the support board that runs left to right to support the table when in bed configuration. I will double check.

Can someone provide a photo so I have "evidence" if I have to ask the dealer in case they give me the "not sure what you are talking about" look?

Thanks,

Esteban

 

[Dave S]

I would just have them get you one out of another 260DA.