1987 300 sedan bridge

[Back in action]

I’m totally new to this so here we go . A few months ago I bought in 1987 300 sedan bridge which had been sitting at a lift for like 10 years. A few months later and a few thousand dollars into it the boat is finally working. One question I do have is..... does anybody know where the cap for the pump out is located? The boat does have a holding tank and a vacuum flush which I haven’t used or gotten to work yet but before I do I need to know where this pump out is so I can pump it at the dock later on. I must be blind but can’t locate it. Thanks

 

[JimG]

Maybe it doesn't have one... maybe only a macerater. Should be easy to tell by looking at the holding tank and it's hoses.

Here's some reading for you:
http://www.clubsearay.com/index.php?threads/official-1980s-weekender-sundancer-300-thread.51786/

Welcome to CSR!

 

[Back in action]

Maybe it doesn't have one... maybe only a macerater. Should be easy to tell by looking at the holding tank and it's hoses.

Here's some reading for you:
http://www.clubsearay.com/index.php?threads/official-1980s-weekender-sundancer-300-thread.51786/

Welcome to CSR!

Thanks Jim. That’s what I thought but can you expand on what you meant at looking at the holding tank hoses?

 

[JimG]

Thanks Jim. That’s what I thought but can you expand on what you meant at looking at the holding tank hoses?

You should be able to see 1 input hose and 1 or 2 output hose(s). If you have a macerater, you should see a hose going to a Y valve or directly to a sea cock. If you have a deck plate you will see a hose going up to the side wall.

Take pictures and post here if you can't figure it out.

 

[Back in action]

You should be able to see 1 input hose and 1 or 2 output hose(s). If you have a macerater, you should see a hose going to a Y valve or directly to a sea cock. If you have a deck plate you will see a hose going up to the side wall.

Take pictures and post here if you can't figure it out.

I will do that, awesome!

 

[Back in action]

You should be able to see 1 input hose and 1 or 2 output hose(s). If you have a macerater, you should see a hose going to a Y valve or directly to a sea cock. If you have a deck plate you will see a hose going up to the side wall.

Take pictures and post here if you can't figure it out.

Unreal I traced it out from the holding tank like you said, zip to any deck plate. The output hose goes directly from the tank to a pump and then through the hull to the first hole in the picture! Right through the hull and not even under the water line like I’ve already seen most do for in the ocean discharge. So I guess i can’t pump it out at the dock.

 

[sbw1]

Unreal I traced it out from the holding tank like you said, zip to any deck plate. The output hose goes directly from the tank to a pump and then through the hull to the first hole in the picture! Right through the hull and not even under the water line like I’ve already seen most do for in the ocean discharge. So I guess i can’t pump it out at the dock.

You're going to need a bigger bladder.