billandlori
New Member
- Jul 6, 2019
- 22
- Boat Info
- 1972 Sea Ray SRV190
- Engines
- 455 Oldsmobile/Berkely Jet
I didn't get too much time over the long weekend to work on the boat but have still been picking away.
I got all the foam out of the front bow area, it was in good shape and really hard to get out. Had a slight gas smell so there must have been a leak or spill at some point.
I was kinda weird how they built a higher section in the bow area, sure was a lot of foam!!
Then today I got after getting the engine pulled. Lots of documentation of wires and such. This has a three point engine mount, two mounts on each side of the engine block and the bell housing mounts to the input shaft housing on the jet pump.
The supervisors were on hand to make sure everything went safely...
Next is some cleaning and pulling the last of the floor and "stringers" out.
Bill
I got all the foam out of the front bow area, it was in good shape and really hard to get out. Had a slight gas smell so there must have been a leak or spill at some point.
I was kinda weird how they built a higher section in the bow area, sure was a lot of foam!!
Then today I got after getting the engine pulled. Lots of documentation of wires and such. This has a three point engine mount, two mounts on each side of the engine block and the bell housing mounts to the input shaft housing on the jet pump.
The supervisors were on hand to make sure everything went safely...
Next is some cleaning and pulling the last of the floor and "stringers" out.
Bill