Search results

Problem fixed. replaced the latching solenoid (next to the breaker) and anchor works perfect now.

I have a similar problem. My windlass does not work. The light on the panel is on but when you press the switch you can hear a click on the front but the motor does not work. I already checked the breaker inside the engine compartment and is good. I notice there is no power coming to the...

The trim tabs on my boat are not working, when you press the switch you can hear the pump running but the tabs don't move. I checked the fluid and it was full. The pump on this boat is a bennett v351. I did notice that when I press the switch (up or down) some times the pump does not run, but...

I have a 2002 280 Sundancer on a 13500 GVWR trailer and use a Toyota Tundra 4x4 to pull it. I have 3 years with it and never have a problem with it. The Toyota does a great job and is also a nice daily drive vehicle. The marina is about 7 miles from my house. Keeping the boat on dry storage is...

How do you test if you have a good ground? With the tester I know there are 13.9 volts going in the EIM.

I jumped in the boat yesterday and all the switches were working fine, how can this be possible? This had happen before, I go out on a full weekend and one day all my switches are fine and the next day they are all gone. Sometimes all the lights on the panel are off but my lights are on, my horn...

I'm looking for somebody that owns a 280 Sundancer (2001-2004). I need to borrow one switch from the panel to make sure mine does not work. I don't want to buy it from Searay at $400 and then eat it if is not the cause of my problem. I will take care of removing the switch from your boat and put...

Thanks for the information. Do you think the switch panel is good because all the LEDs light up when you disconnect and connect the switch panel? Thanks

I have a 2002 280 Sundancer and the panel switch that control my lights, radio, anchor, fresh water, etc.. is giving me a lot of problems. Some days it works and some days is dead. When I unplug it and plug it back all the lights on the panel lights up but 1 second later the panel is completely...