Search results

Thanks John, so the roller wheel is the small part that fits over the post beneath the oven base in the centre of the oven space?

They rotate both ways down here.

Hi, the Sylvania microwave on my 2007 Sundancer 260 is missing the plastic carousel which makes the glass plate rotate. With this missing I cannot use the microwave. I have tried emailing Sylvania but they never return my emails, and I've emailed SeaRay with no response either. Can anyone...

Hi, the Sylvania microwave on my 2007 Sundancer 260 is missing the plastic carousel which makes the glass plate rotate. With this missing I cannot use the microwave. I have tried emailing Sylvania but they never return my emails, and I've emailed SeaRay with no response either. Can anyone...

I have a 2007 Sundancer 260. I have just purchased a 3.2kVa generator for the mail purpose of recharging my batteries. I have the boat on a swing mooring and rarely get to connect to shore power to fully recharge them. I connected the generator up for the first time on the weekend and...

Thanks guys, looks like the 3.2kVA will more than suffice. Appreciate your replies.

My 260 Sundancer is on a swing mooring so I do not have ready access to shore power to fully recharge the two batteries. I am considering purchasing a 3.2kVA generator so that I could recharge the batteries and run a couple of appliances (lights mainly) so that I can give the batteries a rest...

Thanks heaps to all who have replied. Yes, it's the Smartcraft. Will do a few simple checks next weekend and then will probably have to get a new transducer. Will let you all know the outcome.

I have a 2007 Sundancer 260 and when I used the boat this weekend I noticed the Depth Sounder was not recording the depth. The display looked like this: _._M. The water temperature also read -35. It should have read about 25C. I checked the hull to see whether there was any growth where the...

I had exactly the same problem and replaced the duckbill valves. Works like a charm now. Horrible job though!

I have a Sundancer 260 (Australia) with the 5.7l MPI engine. I find that at 1500 rpm I'm consuming 8.3 litres/hr. I think that's pretty good economy.

I have a Kenyon Kiss Cooktop on my 260DA and for some reason the gas flow has dropped to the point where it will barely stay alight. It was working fine until a week or so ago and now we can't get enough flame to even boil the jug. Does anyone have any suggestions/ideas?

My 2007 260 Sundancer had 900 hrs on it when I bought it and it runs like a dream. Like everyone has said - maintenance is the key.

I had a problem on my 260 where the head wouldn't flush at all. The vacuum pump would run continously but would not hold vacuum. I replaced the four duckbill valves (messy job) and it works beautifully. Good luck.

I've got a 260DA with a Vacuflush toilet. I had an issue where I couldn't get any vacuum and the thing wouldn't flush. I literally pulled the entire thing apart from the bowl to the storage tank - hell of a job. Anyway, I replaced the 4 duckbill valves and it now works like a charm. Looks...

Ours started to beep forno reason so I disconnected it - problem gone away :smt038

Thanks for the tip - I bought a daddi long legs and it works great.

We've had our 260DA for a month. Following its voyage down the coast in fairly rough seas, the well beneath the stairs was full of water which, in turn, wicked through to the cabin carpet which made it saturated. Since then it has dried out and not recurred. We haven't been in rough seas...

Thanks to everyone who responded. I won't bother trying to lift it and risk breaking the mirror.

Gidday mate - welcome to the club. I've only been a member since we bought our 2007 260 DA (same as the 275) a month ago. This is a great forum for asking those tricky (and not so tricky) questions. We are having a ball on our new toy - spend every weekend on it down at Nelligen on the Clyde...