Hi All
I have a 1995 sundancer 29. it has a shower pump under the stern berth.
I would like to know where the fuse is for this pump. Is it wired ac or dc ?
Any help is appriciated
Thanks
Paul
SUNDANCER 29,BRAVO 3,7.4 SINGLE ENGINE.
no growth on bottom,just changed impellor,oil and plugs done, new oil in leg.
went out yesterday,and tried to get some speed to plane. engine was turning over at just under 4,000rpm and only got about 10mph.
limpped back to dock,and even going at about...
Took my boat out for a run yesterday,its a sundancer 29 with a 7.4 and bravo 3.
So gave it more gas and engines getting up in the 3,400+ range and im not even managing to do 10 mph. As ive got it reving so high the engine then overheats .
ANY IDEAS PLEASE
Thanks paul
Hi Everyone
Went over to the boat the other day,switched the d/c on went below and noticed a pump running.
Found it was the a/c water pump running even though the a/c is not switched on.
I have closed the water inlet valve at the start of winter,so i know there is no water going into...
Hi
My sea ray 29da cannot drain the shower.
As ive read a lot of post it sounds like its a common problem.
My question is... where is the shower sump pump ?
Where do i find location pictures ?
thank you
Hi i have a 1995 29',and have a tv and dvd that i would like to watch while on the hook.
How do i do this on battery power?
I have a 12v outlet in the gally area near the tv.
Thanks :thumbsup:
:smt100Ok so i about to drill holes for davits,should i drill a larger hole than needed fill with resin and let dry? Then drill my davit holes through that?
or
Should i be ok drilling straight through the swim,and just put bolts and large washers in?
I have a 29,and its a 10' 75lb...
Hi i have a 1995 sea ray 29,and it has the short transom.
I am looking at fitting a set of weaver davits for my 75 pound dingy.
Method i was going to use is.. drill through platform,place anti slip on base of spring clip and place bolt through.
Place a steel plate on underside of platform...