Search results

All, I'm about to replace my port switch pad on my Sundancer 300. However, the panel only comes in black. Please see the attached image that shows the method, that I received from Sea Ray HQ, to replace the black panel with the original woodgrain panel. Hope this helps anyone replacing their...

I recently started my starboard engine and heard an alarm that beeped twice and noticed that the automatic halon system light was off (usually is on if everything is ok). When I started the port engine, the light came on with no alarm. I checked the fire extinguisher and it was still in the...

Does anybody have any tips on how to remove the starboard blower on a 2002-2007 300DA? I found an access panel next to my aft bench seat, but can't see the blower. I can feel it, but don't know how to remove/replace it. Thanks in advance! Eddie

I'm having trouble rewiring my cockpit speakers from the old 2 cv amp to the new 4 ch amp. Can anyone tell me how to wire the speakers in parallel on the 4 ch amp? Which speakers are paralleled with each other. The arch speakers aren't shown the schematic in the owners manual. Thanks in...

I'm helping a friend replace his fuel filters and can't find the fuel cutoff switch for them. Anyone know where they're located? Thanks in advance! Eddie

I've been chasing this vibration since last September. Thought it was engine related - replaced all wires, plugs, ignition coil, disributor cap, fuel filters, IAC, IAC air filter, cleaned flame arrestor, checked risers, checked engines on computers (they run within 5 RPMs of each other). Now I...

I know there have been many posts about mods to our sundancers, but I haven't seen any posts regarding a sub and amp in a 300. I'm thinking about putting one in the helm seat facing outward like on the 44 sundancer I saw, but I wanted to know if anyone has done this and how hard it is to wire an...

I know there have been many posts about mods to our sundancers, but I haven't seen any posts regarding a sub and amp in a 300. I'm thinking about putting one in the helm seat facing outward like on the 44 sundancer I saw, but I wanted to know if anyone has done this and how hard it is to wire...

All, I'm starting to look at these 2 boats for a friend. Any thing in particular to look out for in terms of major drawbacks? I already know that he should get diesels, bow thruster, smartcraft, hardtop. Just want to know what I should expect before the surveyor gets involved. Thanks...

All, I'm trying to determine which GM parts can be used for our 5.0 MPI engines. Anyone ever done this cross reference before? For example, our spark plugs, AC 41-932's, are $18 from Sea Ray, but one can go to Advance Auto Parts and get them for $6. There must be many other instances of...

All - reposting this thread here, because no one responded in the Sport Cruiser section... I have some questions about how to change the impeller on my Westerbeke 4.5 bcgb generator: Has anyone else performed this changeout? How do you get to those little phillips head screws to open...

I have some questions about how to change the impeller on my Westerbeke 4.5 bcgb generator: Has anyone else performed this changeout? How do you get to those little phillips head screws to open the impeller cover? I figured you have to take the hose going to the heat exchanger off, but...

All, Just wanted to let those who don't know anything about bilge pumps and their associated floats (in the rectangular white shell, next to the bilge pump) in on a minor occurence that happened this weekend. Experienced boaters need not read on... My sump bilge pump (under the carpet in...

All, Just had a failure this weekend on my IAC (controls engine idle speed/start up air mixture). This part is about $90 and is very easily replaced in 2 minutes. The reason I'm posting this is that I feel you should have one of these, and the gasket that goes with it (doesn't come with the...

Hi All, This is my first winter with my 300DA and I'm doing all my own winterization. I poured 3+ gallons of anti-freeze in my water tank, and proceeded to open all the faucets. However, my galley sink faucet didn't produce anything but a trickle of water. All other faucets eventually...