Search results

Folks, I've got a 1993 27' SeaRay Weekender, and the text on the NMMA Certification Plate (part number C-69 126062) is no longer legible. I would like to replace it with a new one, but I can't find a supplier on the internet, and I'm not close to a SeaRay dealer. Anyone know where I can get a...

Folks, I've got a 1993 27' SeaRay Weekender with a broken bilge pump switch (for the engine compartment bilges). I must have leaned against the switch (which is lower left of the steering wheel) and broke the "toggle" part of the switch. I'm attempting to replace the broken switch and ran into...

Folks, I have a 1993 27' SeaRay Weekender that needed a new canvas top. Earlier this year, I ordered all pieces of the canvas from Great Lakes Boat Top (GLBT, who is the OEM manufacturer of the canvas top and the SS framework) even though I suspected the SS framework had been altered and that...

Folks, I've got a 1993 27' Sea Ray Weekender. I'm replacing all the canvas covering on the boat. I got lucky and found the OEM canvas manufacturer for the boat ... Great Lakes Boat Tops. They are the OEM boat top manufacturer for Sea Ray and many other boat brands. Give them the boat's hull...

Folks, I've got a 1993 27' SeaRay Weekender. I'm changing all the incandescent light bulbs to LED (navigation, cabin, etc.) and have a problem/question about the cabin lights that, in my configuration, are in the low "fishing rod storage" area next to the rear-facing seats. See the attached...

Folks, I have a 1993 27' Sea Ray Weekender with MerCruiser 7.4L on Smith Mountain Lake in Virginia. I recently had a substantial amount of MerCruiser 7.4L work done by David Lonas ("Moneta Mobile Marine") and am very pleased with his attitude, responsiveness, knowledge, technical capabilities...

Folks, I've got a 1993 27' Sea Ray Weekender with a 7.4L MerCruiser engine. The current MerCruiser 7.4L is an OEM long block that was installed about 10 years ago that has about 250 hours on it. The boat has not been used in 2 or 3 years, but it was occasionally started and ran for 10 - 15...

Folks, I've got a 1993 27' SeaRay Weekender that needs new canvas. I want OEM canvas, and I know that Great Lakes Boat Tops can provide OEM canvas for some, but not all, of the needed canvas sections. Specifically Great Lakes Boat Tops can provide the convertible top section, (2) side panel...

Folks, No gas is getting to the carb in my MerCruiser 7.4l engine. This engine has the configuration in which the fuel pump is connected to the raw water pump, and the water pump drives the fuel pump The fuel pump has been disconnected from the water pump, and I can look into the "cavity" of...

Folks, My 1993 27' SeaRay Weekender (7.4L Bravo 3) won't start. It cranks fine with 2 new 800 CCA batteries. I presume it's either a fuel flow or electronic problem. I have "reset" all the circuit breakers in the breaker box within the engine compartment. When I "reset" each of these breakers...