Nevermind, I figured it out. You have to push in on the red connector, then pull the tube out. Then you can pull out the male end of the connector. Then you trim a bit off the end of the tube and reinsert it into the male end of the connector and hook it up again. I thought this might be...
Does anyone know if it's possible to disconnect a Kahlenberg instant connect fitting? My compressor failed and I'm trying to replace it, but I need to get a quick connect fitting apart. I don't want to apply too much force so I don't break it.
The water heater is under the floor of the lower salon, pretty much even with the galley sink, and the water tank sits just forward of that. The water heater discharge is right under the sink, just like the diagram above. I'm wondering how long the current T&P valve is going to hold out before...
It was the T&P valve. I cycled the valve a few times, then turned the fresh water pump on and it held pressure. That's the good news. The bad news is that it only seems to hold pressure when the valve "switch" is turned up, but it still leaks when it's down, so I've ordered a replacement to...
I have not done that because I don't know how to, but this sounds like a promising lead to me. How do I do that? If this is the problem, can I just replace the valve?
I neglected to mention that I did try running the pump with all of the shut-off valves at the manifold under the galley floor turned off, and the pump continued to run. I thought this might mean that there is a problem with the pump itself, but it seems to be moving water somewhere since water...
I'm having a few problems with my potable water system, and I think I'm in the midst of trouble shooting them. It's a 2014 510 Sundancer.
We spent a day out on the boat recently and emptied a full fresh water tank in a matter of hours despite not using much water, so I started doing some...
After doing your test I'm guessing it's the bellows, based on where I saw it leaking from. At least we have another head to get us home! I wanted to finish enjoying Cedar Point with the family before tackling this unsavory chore...
It is waste and fluid in the bilge. The holding tank was emptied a few days before this trip while showing it was 3/4 full. We didn't notice a problem unitl a couple of days into the trip.
We are on our first overnight trip with our new to us 510 Sundancer. Last night my wife noticed an unpleasant odor when returning to the boat. She has a more sensitive sense of smell than I do, and I didn't really notice it. Today I did, though, and when I opened the bilge to investigate I...
This is my first season boating at all, so I don't know how common this is in general, but I haven't found anywhere in the Erie islands that will let you reserve a spot just for the day, so you have to call same day and hope they haven't filled up with overnight reservations. I booked an...
After a phone call to Sea Ray I figured out the control box is above the starboard ceiling panel above the wetbar. The guys I spoke with at Sea Ray and Sureshade were both very helpful and it was an easy fix once I found the box. Sorry aboit posting this in the wromg forum. It was meant for...