Search results

  1. M

    Engine cutting out and quickly recovering.

    I have a 1996 330 Sundancer with twin 7.4 V Drives. The other night my port engine was dropping out about every 5 to 10 seconds and then quickly recovering. I brought the boat in and changed the fuel filter. Same issue. I swapped the coils. Same issue. I then changed the fuel pump. The boat...
  2. M

    12v television draw on twin deep cycle.

    If I run a 32 inch LED television overnight on the two deep cycle house batteries, would I have a problem starting my port engine the next morning? Any thoughts? I'm thinking to replace my 120 v television with a 12v so I don't have to run the generator overnight. Or would I be better off...
  3. M

    330 sundancer table dimensions

    1996 330.. I'm trying to get the dimensions for the cockpit table. The rectangular, fiberglass one that stores underneath the aft bench seat. I'm fabricating a new table and don't have access to the boat. Thanks for any info. I believe it would be the same for any 1995 to 1999
  4. M

    330 sundancer table measurement

    Can anyone give me the dimensions for the stock rectangular fiberglass cockpit table for a 1996 330 Sundancer? This would be the table that stores underneath the aft bench seat. I'm quite a distance from my boat right now and I'm looking to fabricate a new table but I want to make sure it'll...
  5. M

    1996 330 sundancer. Analog to digital conversion for MFD's

    Hello all. I have a 96 330 Sundancer outfitted with a Seatalk backbone. Connected to the backbone I have a Raymarine I70s, a Raymarine e7, and a Raymarine e7d. The I70s and both MFD's will currently receive and display GPS and transducer data only. Question is... How do I tie in the other...
  6. M

    Running cockpit fridge on house batteries.

    I removed the ice maker in the cockpit that was not functioning on my Sundancer. I'm replacing it with a mini fridge that draws 1.5 amps at 120 volts. (180W) My plan is to bring a line up from the house batteries that are in parallel and feed a AC inverter to run the refrigerator on 120 volts...
  7. M

    7.4 thermostat and housing question....

    Hello all.... I replaced my manifolds and risers on my fully closed loop system and while I was working, decided to check out another possible issue. The temp gauges always read cool, so I thought maybe there were no thermostats installed. Before I checked, I purchased 2 new thermostats and 2...
  8. M

    Cooling question

    I was in touch with Mercruiser and they ran my serial numbers for my 7.4' s. They told me I have raw water cooling. Here's a photo of my manifold and elbow. I will be replacing both or maybe just a cleanup and bolts and gaskets. These manifolds are actually fresh water cooled correct? They have...
  9. M

    Bow rail backing plate

    Hello all. Got a quick question. I purchased a 96 330 Sundancer and the bow rail on the port side by the head window was lag bolted. It's loose and the deck has some water damage. I believe I can get access in the cabin by removing the microwave. Upon inspecting the other stanchions, I...
  10. M

    New Owner of a 330 Sundancer, and new on the forum

    Hello everyone. I live in NJ, and just purchased (Oct, 2019) a 1996 330 Sundancer. My first boat, and absolutely loved my first few months on the boat before winter storage. I'm looking forward to getting it back on the water in April, and enjoying my first full season. I'm a member of a few...
Back
Top