I began the pre-season clean up over the weekend and noticed my port side actuator had some fluid residue at the top (pic attached). My assumption is that it could be a bad "O" ring? Is this residue common after sitting all winter? Could there be an issue with the pipe nipple or hydraulic lines?
Hello All,
I ran into a no power connection on dash gauges for my 2007 240 Dancer 5.0 MPI Bravo III.
I was out on the lake all day the weekend before, got back to the slip without an issue. The following Saturday I went to start up and was not receiving power to the smart craft or any dash...
Replaced my lower unit oil last week. Followed the proper procedure as far as pumping in from bottom until oil came out top vent plug. I then put the vent plug back. I gave it 4-5 more pumps I noticed there was way to much oil in the reservoir so I took the bottom bolt off to let some drain...
Hello everyone. I just recently purchased a 2007 240 Dancer and the cockpit speakers are not working (they weren’t when I purchased which helped in negotiations.) The first thing I did was purchase a new Kenwood marine head-unit and had a local stereo store install. The cockpit already had 2...
Hello everyone. I just recently purchased a 2007 240 Dancer and the cockpit speakers are not working (they weren’t when I purchased which helped in negotiations.) The first thing I did was purchase a new Kenwood marine head-unit and had a local stereo store install. The cockpit already had 2...