Search results

  1. G

    Tranny question

    I have a 2004 42Da with the ZF2801V transmission in it. Recently we had a transmission cooler failure and it ruined the transmission. Actually the transmission was empty of all oil from the bad cooler and locked up and spun the engine coupler too. Pulled the transmission and dropped it off at...
  2. G

    Cat 3196 not spooling up past 1500 RPMS

    I have a 2003 - 51 Sundancer. I have had the Cat techs out to pretty much diagnose why both engines will not exceed 1500 rpms full throttle. Alot of work has been done to them. I am looking for something that might be causing this. Here is the what was done to the engines so far: New turbos...
  3. G

    Wiper motor solenoid valve for washer

    Starboard wiper motor works great. The minute I hit the washer it pops the breaker (Breaker is brand new too). It is on a 2003 - 42 Dancer. Does anyone know what part number the solenoid valve is for this? I want to replace it but may have to call Searay for help. I did call MM and got the...
  4. G

    Shock cords for canvas

    Any one know where to find the bungee (Shock cords) that are attached to the canvas on Searays? Looking to replace all of mine on a 51 Dancer.
  5. G

    Exhaust muffler leaking at base

    1999 - 54DA I have a stream of water flowing in bilge when my starboard engine is running. Found the leak is coming from the large black fiberglass muffler that goes thru the hull and muffles the exhaust noise. Can it be removed and repaired while the boat is in the water on needs to be...
  6. G

    Cats3196 will not spool past 1400 RPMS

    I have a 2003 - 51 Sundancer. I have had the Cat techs out to pretty much diagnose why both engines will not exceed 1400 rpms full throttle. Alot of work has been done to them. I am looking for something that might be causing this. Here is the what was done to the engines so far: New turbos...
  7. G

    Cummins 6CTA overheating at WOT

    Need help with 42 foot SeaRay with twin Cummins 6CTA's. Port engine runs perfect. Starboard engine runs over 210 degrees if throttles are 3/4 to fully open. The minute I slow down the temp backs down to 160 degrees. What am I missing? I did the following: Cleaned thru hull of any debris...
  8. G

    Problem with helm gauges

    I have a 2003 51DA and recently had all the gauges at the helm quit working. They worked perfect before and no work has been done to the boat prior to this happening. I unplugged all gauges except one and still nothing. I have voltage going to all of them but it seems they are unable to read the...
Back
Top