Search results

Ha! Turned out the pump had a 32A fuse blown discovered by repairman. Once replaced all running fine. Thanks to all for trying to assist! Billy M

AC problem. Water lines clear and no air lock. AC compressor comes on but not pump so AC shuts down. Either pump is faulty or pump relay ( have three units) is faulty or both. How can I tell which to replace? Thank you, Billy M

Ok will open relief valve... let you know tomorrow... thanks.

Right ..I’m going to buy a clamp meter tomorrow and check for power to the Tstat and element. Thanks again

150

150

Yes but water still lukewarm. Amp changes but water temp does not...so TS not sending power to the element? Why? Thank yo so much for your time and comments.

Correction: Amp shows 10 and VM shows 120...

Dissapointed about not being in heaven but......the amp meter on the panel went to 20 when I switched on the HWH so I think power is going to the unit. Waited 10 minutes.... water cold. Could new thermostat be bad? I’ll go get another (3rd) element tomorrow ... wife going to live with plumber...

I’m replacing the beaker for practice. The element shows continuity so going to assume it’s good. Going to fire her up. If I don’t reply it means I’m in heaven.... I hate electrical!

Thanks... sounds logical of course. Could the water heater breaker be weak or bad? Should I Ck breaker continuity?

Ran engines in slip and Water hot for very short time like 15-20 sec then goes to Luke warm.

Yes I’m pretty sure... water Luke warm but haven’t checked breaker...

Not sure how to do that ... water off? Drain heater? Refill?

Not sure how to do that... water off? Drain heater?

I have a 1989 SeaRay 410 with 12 gal Raritan hot water heater ( and Heat exchanger). Water is still Luke warm after replacing both the element and thermostat. Any advice would be appreciated. Thanks.. Just Peachy