Search results

I know it was posted before, but I lost the link. I have Raymarine instruments on my'98 Dancer. the depth finder display is fading and I would like to get it repaired. Does anyone remember the link/company that performs repairs?

I have a '98 DA w/8.2's No MAS but fuel injected. I am having a problem obtaining max rpms with starboard engine. I replaced all sensors I could find on the plenum, gaskets idle position sensor to no avail. boat runs great, gets up on plane with no problem but engine will not rev above 3800...

Sorry I did not see your post sooner. I will get back to you soon. currently on the hard, but its too damned cold to visit the boat yard. next week or so should warm a bit.

I live locally and share your concern. If your boat was winterized properly and covered, you have little to worry about. Rock Hall harbor is fairly protected and while it will freeze up, the use of the bubblers help prevent the boat from becoming one with the ice. Major pieces of ice are a...

thanks. just need to know where to locate it. I think its under the intake, but I'm afraid to lift it due to the wires being restricted. I have looked under[lifted until felt resistance] and noted wires going to bottom.

I have a '98 37DA with 8.1 Horizon engines. port engine runes fine, reaches max rpm. Starboard engine idles surge, sometimes stalls, cruises ok. but can't reach max rpm. after investigating plugs, wires and distributor, fuel pump etc. have come to the conclusion its a sensor. It's a FI...

I have a '98 with the Horizon's. I have 4 blade props and cruise at 22 knots 3250rpms. WOT is 4400. it burns about 32 GPH at cruise. I know others with same boat but less HP. Takes more time to plane with 310's with a load of people/junk. 340's better. More Hp is usually for top end, and...

Do you have a son/grandson who is thin and nimble? That is your best option, lol! Agree with others that it looks more involved than it is.

Thanks for your reply. On my engines, the exhaust hose prevents removing the arrestor.

While performing maintenance on my '98 Dancer with Horizon engines, I removed the plenum to access the spark arrestors. I figured that while I was there, I would clean the MAS. To my surprise, I could not locate one. These are fuel injected engines, and to my knowledge, all have some type of...