Search results

  1. B

    Water in trim pump reservoir?

    Before I put the boat in the water I tested the trim tabs on both sides,and they went all the way up and all the way down. Go to the boat today and starboard side looks like milk inside the reservoir. Clearly getting water in there. I imagine I need to replace some wore out seals.How will this...
  2. B

    Syncing Outdrives

    Just had the boat shop replace my dual throttle base and cover on my 340.I also asked them to sync the outdrives. Did they need to run the motors with water muffs to do so? I forgot to ask them that question.
  3. B

    Boat Soap

    Do you see any problem with using Woodys boat soap with wax on my Sunbrella covers as I am washing the boat?
  4. B

    Correct Sealant?

    What would be the correct sealant to seal between my arch and the side of my boat?And what about to re-bed my porthole windows and my hatch covers?I see 3M offers a couple of good products, 4200, but it’s not UV resistant and then 4000 and it is UV resistant.What about other brands? Any idea...
  5. B

    Caulking

    Wondering what the correct caulking is to put a tight bead around my stanchions, cleats, etc.? Looking for something permanent and non-yellowing.
  6. B

    Water Intrusion

    Helping a buddy this weekend do some repairs on his 99 270 DA and we found some water intrusion around the anchor chain safety lanyard base that through bolts onto the deck. The rot has worked its way back about 7 inchs to port. We were able to dig it all out to solid plywood.We did verify...
  7. B

    New throttle controls

    I currently have Binnacle Mercury dual I/O throttle controls. And what I believe to be GEN one new throttle and shift cables.Installed two years ago. My question is is I’d like to go with a more updated throttle control. I have spent a boatload of money remodeling the entire dash, gauges...
  8. B

    Exhaust manifolds

    I have a 1999 340 Sundancer 7.4 MPI with bravo one outdrive’s fresh water boat. I was hoping somebody could chime in and direct me to the proper OEM exhaust manifolds for this fine boat?Thank you gentlemen
  9. B

    Standard Purchasing procedure?

    I am looking to purchase a 2001 - 2003 410 Sundancer. Will somebody be willing to share the purchasing procedure with me once I find the boat I like? Do I fly down and look at the boat and then make an offer? Do I make an offer sight unseen based on what I am being promised the boat is? So on...
  10. B

    Looking to buy 2000 era 410 with gassers

    We are wanting to move up from our 1999 340.We are liking the 2000 era 410 with gassers. We are on a very small fresh water lake in Utah.Why gassers? Our local yatch club only offers gasoline.Any advise and/or leads on that vessel would much appreciated.
  11. B

    Tying off your anchor correctly

    We have a 99 340 Sundancer with 200 feet of all chain road with a windless. How are you guys securing the chain to the cleat, to release the pressure from the windless? We boat in Utah so we don’t have the big ocean waves to give stress to the windless.
  12. B

    Loose cleats 99 340 DA

    We have owned our boat for three years. Usually trailering it to different lakes throughout Utah. This year we decided to join our local yacht club and slip the boat. I noticed last week that all my cleats are becoming loose. I have bow lines, spring lines for and aft,stern lines,and I have...
  13. B

    Loose cleats 99 340DA

    .We have always trailered the boat to different lakes. However this year we decided to join the yacht club and slip the boat. All of my cleats are working loose! I have bow lines,spring lines for and aft, stern lines. I even have snubbers on the bow lines and the stern lines.Is this normal? The...
Back
Top