Captain seat if like mine, the rails come off from the storage area from the seat behind it, the lounge seat is unbolted from the aft cabin
Sent from my iPad using Tapatalk
Also if take up the bottom cushion, on mine I have built in "cooler" on the left and storage on the right. If you look in the storage area on the right you will see screws that give you an access panel as well to help run the wires up.
But for behind the dash, the only access is to pull fuse...
As you can see from the photo the the old piece was pretty rotten. But enough to give me template. From here I used marine plywood and marked were the bends would be. I used my skill saw and in the zones were the curves were I adjusted my saw not to cut all the way thru the ply wood. And then...
I just re-did mine , the wood was rotten, but enough to make a template. Hit me up if you you would like a walk thru and pics
Sent from my iPad using Tapatalk
A Bluetooth speaker, Altec Lansing super life jacket is what I have it sounds good, it's water proof, floats and even comes with a mount that fit on the rail
Sent from my iPhone using Tapatalk
Not this trip, if you make future crossing I might be down, just bought a 96 270da still going through her to ensure a good trip
Sent from my iPhone using Tapatalk
Thanks, it's seems like it would be fairly on point, when started the Rpms are about right between 6-900 , gauges were put in this winter due this and it was also time for a refresh, when installed they were correct, but after she was started it went back
Sent from my iPhone using Tapatalk
Rpm gauge issue : I got my 270 in the water this past week. She ran good. When I bought it I noticed the rpm gauge was stuck at about 800rpm, I replaced all all the gauges and updated the drivers helm area, after the gauge was good till I took fired her back up the rpm gauge went back to...
Rpm gauge issue : I got my 270 in the water this past week. She ran good. When I bought it I noticed the rpm gauge was stuck at about 800rpm, I replaced all all the gauges and updated the drivers helm area, assumed this would take if it but after the upgraded the rpm gauge went back to stopping...
Rpm gauge issue : I got my 270 in the water this past week. She ran good. When I bought it I noticed the rpm gauge was stuck at about 800rpm, I replaced all all the gauges and updated the drivers helm area, after the upgraded the rpm gauge went back to stopping at 800 or so , it reads while the...
I know it will go in to a black water tank, but was not sure of the flush water came from. Thank you again, taking her for the first time tomorrow
Sent from my iPhone using Tapatalk
I have a question around how my toilet and water system work, I have never had an Macerator system, does this require water to be aboard or will it pull water from lake? It's a 96' 270
Sent from my iPhone using Tapatalk