Frank, I dove under and checked everything and all looked good. Not mechanically inclined but leaning towards fuel filters, water/fuel seperator filters, spark plugs etc.??
Boat ran perfect Friday night but yesterday noticed my hole shot was off a little and then at my normal running rpm's my speed was down about 2 miles per hour. Checked under boat and all looks normal. No noticeable difference in engine sounds. Any advise?
No growth on bottom and all conditions were similar. Was able to run up to a little over 40 miles per hour easily. Normally at 3400 rpm's I am doing 28. Yesterday 26 and I could tell something just wasn't right.
Boat ran perfect Friday night but yesterday noticed my hole shot was off a little and then at my normal running rpm's my speed was down about 2 miles per hour. Checked under boat and all looks normal. No noticeable difference in engine sounds. Any advise?
RichG and bjac do you have any follow up? I am having the same issue on one of my windows. It appears the water is coming from between the outer frame and the side of the boat because when I tested with a hose just on the glass area, no leaks. When sprayed above window and allowed to run down...
Generator starts and runs for 3 seconds and shuts off. I last had it running about 2 weeks ago and it did same thing but finally started and ran fine under load for an hour.Tried the other day 15-20 times, but would shut off each time. What gives?
John, I keep my boat in a slip at Lighthouse Marina and you will not be disappointed. Great Marina and Lake Murray is incredible. I will start plugging for you with the folks in charge. Not a lot of movement in the covered slips, but enough that I would be surprised if you are not in within 6...
Not cordless, but I have the Mighty 500 watt detailing vacuum.
http://www.griotsgarage.com/p2p/searchResults.do?method=view&search=basic&keyword=vacuum&sortby=newArrivals&page=1
Compact and easy to store, lightweight and powerfull.
Fred, I replaced mine with a Ray55. The height of the existing bracket is almost identical, a little snug, but the width was off leaving a small opening on either side of the radio. I shaped a piece of Balsa wood the same exterior dimensions as the current bracket and just made the cut out...
John, just got back from boat and can confirm some of Henry's measurements. 32 1/4" wide and 15" high. You have 10 1/2" from bottom to the grab handle mounts. The latches are set in 4 7/8" from each side and 1 1/2" from the bottom and there is 17 5/8" in-between the two latches. From the bottom...