Search results

Did you ever figure out where the water was coming from? I’ve had similar problem with our 2010 370DA....water in the compartment forward of the engine room/bilge bulkhead, under the aft berth. Pulled out the freshwater holding tank and resealed all the fittings as water appeared to be coming...

It could be the electronic interface module (IEM). All the button switches connect through the IEM.....on our 2010 370DA there’s a circuit breaker pad under the cockpit dash..you might check there Too.

Same on my 370DA

Problem resolved after we had the rub rails removed and seams re-caulked

We have a 2010 DA370. The past two years we’ve had a rather significant amount of water accumulate in the middle bilge. Thought we’d corrected the problem by resealing all the hoses and fittings associated with the freshwater tank, but that apparently didn’t do it. Any ideas regarding where to...

Did you resolve the problem? If so what was causing? I’m having similar issues with our 2010370DA

Did you get the issue resolved? If so what was causing the issue. I’m having exactly the same thing occur with our 2010 SeaRay 370DA.

We have 2010 DA370 with AXIUS. Recently noted Vessel View intermittently indicating a starboard engine trim tab and/or crankshaft sensor warning when up on step, oscillating between OK and the sensor warning. At about the same time the starboard electrical circuit started to malfunction...

I’m having similar issues with our 2010 DA370 - have AXIUS as well. In our case Vessel View just started to intermittently indicate a trim tab and/or crankshaft sensor warning when up on step and oscillate between OK and the sensor warning. At about the same time the starboard electrical...

Interesting - the 50 gal tank does have a screw on cover. I’ll check that next. Thank you!

Have noticed water leaking into the mid-cabin bilge. Its not clear where the water is actually coming from but logic suggests is may be associated with the water tank. We have a plastic 50 gal type, however, when we pulled it out and looked it over we didn’t see anything obvious. Often times...

Thanks for the response Jim - I was thinking the same thing but have not noticed any play in the steering. Notably the steering/swivel pin/leak issue occurred back in 2016...had both the port and starboard swivel pins and seals replaced.

Have noticed a slight water drip w/oil streak coming from the back of the port engine (see photo). This started about two months ago. Thoughts??

Thanks Jay — I may have fixed the problem. Seems the bilge pump in the shower sump (which also serves to collect water from AC condensate) was not working. I pulled it out and replaced it with a new 750gph pump and also replaced the check valve. Did all this after detwatering the bilge. Going...

Have recently noted water accumulating in the shower sump/bilge area located under the salon floor of our 2010 370DA. Its not coming from the shower sump/reservoir as the box is sealed tight and the sump pump works fine, but may be coming from one of two drain holes at the back of the bilge...

Thanks all....it turned out to be a faulty sensor.

I have a 2010 Sea Ray 370DA; shower sump is located in a bilge under the salon floor (Attwood model with a 500 GPH pump). This season I’ve noted water accumulating in the aft section of bilge behind the shower sump, with condensate coming from one of two drain holes (left side drain — see...

Port engine spontaneously cuts out while trying to get up on step. Vessel View warning indicates low voltage as the vault. All batteries charged up and generating solid 800amps of power, no loose connections noted. Engine runs fine at idle, running cool, generating 14V, however, it continued to...

Can anyone advise on how to remove the tv located in the main salon of a 2010 370 DA? :smt021 Trying to figure this out has been...frustrating.