Search results

I've been having problems with my generator not registering any oil pressure. It has a "low oil shutdown" that currently isn't allowing the engine to run. I have replaces the oil sensor and verified that there IS oil pressure however it is not registering on the guage. Is this a problem with...

I'm re-assembling the top end on my 94 mercruiser 4.3l and am trying to figure out how to adjust the rockers. It's hydraulic lifter and I've tried setting the preload to zero lash plus 3/4 turn (what the book says) but after 10 mins of running the nuts rattle loose. It doesn't look like I have...

Pulled my manifolds and risers off while doing top end work on my motors. Curious if these are still in good enough shape to still use?

Having a little trouble with my port engine, just started this trip. When trying to get on a plane the engine won't rev up fully. It only revs to 3600 rpm at WOT instead of the usual 4500, while it is fighting to get on a plane it also sputters and backfires. Only issue I've had in the past was...

What should I expect (roughly) for battery life out of my house battery. The boats a 1992 sundancer 300. Just replaced my house battery with a new single 8D deep cycle. How long should this last while sitting on the hook or not plugged into shore power? Basically all I run is my fridge, and the...

Hey guys. Having a issue with my kohler 2 cylinder generator on my 1992 sea ray 300DA. It is getting spark only whil cranking, as soon as I release the start button it loses spark. Any ideas?

Hey all. Just recently purchased a 1992 sundancer 300 with twin 4.3's. New boat but not a new boater, grew up boating and work on boats full time. Ive taken it out a couple weeks now and it's been great so far, just a couple little things to tweak on it (isn't there always) Seems like a lot...