Search results

I have a 2006 sea ray sundancer 240. The trim guage is not working for the outdrive.. it reads that is all the way up. (which its not) . the digital reading isn't working either.. any ideas?

I have a 2006 sea ray sundancer 240 5.0L 265 hp. one of my batteries are bad.. should I get the deep cycle (that's what I have now) or a starter type battery..that way id have one of both...

does anyone have a snap tool they want to sell? I am replacing the carpet in my sea ray and need a tool for the snaps.. thanks

can anyone tell me how many snaps I need for replacing the carpet in my 2006 sea ray sundancer 240 .. My boat is in storage and I cant get to it to count them.. thanks

I live in lake Tahoe, which is 6250 ft in elevation. The water is probably 55-69 degrees and the outside temperature seldom reaches the high 80s.. id say 75-80 is an average summer temperature. I have a merc 5.0L 265 hp motor. about 225 hrs on it..

did u sell the carpet for the 240 sea ray sundancer?

Does anyone have a snap installation tool for sale or rent.. I need to install the female snaps on my carpet..

its got to be the containment box, (under the step leading down to the galley), leaking or over flowing.. that box has a pump in it and takes the water from the sink and the bath vanity and or shower...check to see if the pump in that box is working.

I have a little oil.. maybe an ounce or so of oil in my bilge.. I checked the oil in the motor and it is fine.. it looks like gear oil but im not sure.. is this normal or cause for concern???

I live in lake Tahoe, 6250 ft elevation.. I just reduced the size of my props to 18 pitch .. it helped a little.. im wondering what affect changing to 2.43 gear ratio from 2.2 will have... I have an 06 sea ray sundancer 240 with a 5.0 260 hp merc cruiser.. with bravo 3 outdrive.. I max out at...

Need cockpit cover as above

I have a set of bravo 3 props, very good condition. no dings... stainless steel. front prop is 16", rear prop is 14 3/8". both 20 degree pitch. $500

thanks.i just ordered a double 18p with 4 blades on each.. the front prop is 1/2" smaller and the back prop is 1/8" larger.. im optimistic this will help a lot..

check your outdrive gear lube levels..if its low that will cause the alarm to activate..its mounted on the side of the engine u should be able to see it clearly..

Does anyone know anything about performance chips to enhance horsepower and overall performance for boats? Im at 6250 ft in elevation with a 5.0L 260 hp mpi .. I am running 20 pitch props on a bravo 3 outdrive.Im only getting 4200 rpm wot with me in the boat.. (175lbs)..

I am at 4200 rpm max with just me in the boat (175lbs) and a half tank of gas.. the specs are 4600-5000

I have no power on my sea ray sundancer 240. 5.0L mpi 260 hp at 6250 ft elevation in lake Tahoe. I have the bravo 3 outdrive with 20 pitch 3 blade propellers. Ive been told to go to a less pitch and to a 4 blade. Ive also been told I need to change the gears to the high altitude gear set. (2.2:1...

it ran fine at sea level.. I cant get over 4200 rpms at this elevation

I am in lake Tahoe at 6250 ft. I have an 06 sea ray sundancer 240 with 5.0l mpi 260 hp with the bravo 3 outdrive. Each prop has 3 blades and are pitched at 20. Front prop is 16" in diameter and the back prop is 14 3/8" in diameter. I have no power , the boat planes but it takes a bit..im...

Re: Potential Sea Ray Owner: Is the 240 models from 2000-2006 a good beginner cruise the hull style changed in 2005 . Apparently to improve the planing problem.. the 240 is a nice boat but be sure you get a 5.7 or 6.2 engine. the 5.0 is underpowered for this heavy of a boat , especially at...