Search results

  1. 8

    6.2 MPI horizon crank over issue

    Hi All, I have an interesting issue with my 1987 268 Sundancer that was repowered in 2005 with the 6.2 MPI Horizon engine and a Bravo II outdrive. 2 weeks ago while running in neutral at the dock for about 10 minutes the engine bogged down and died. Tried to restart and it was really...
  2. 8

    6.2L Mercrusier Horizon cranking over very slow, not starting

    Hi All, I have a 1987 268 Sundancer that was re-powered with a 2005 Mercrusier 6.2L MPI Horizon engine with a Bravo II outdrive. Was running OK in neutral at dock for about 10 min when it slowed and died. Tried restart and won't crank over like it did before. Now it turns over like a car...
  3. 8

    Old or New Alpha Exhaust bellows

    Hi all, I have Alpha one Gen one replacing exhaust bellows. Original are accordion type. the SELOC manual says it can be replaced with bellows that only attaches to gimbal housing and contacts outdrive when lowered. Gives a part number B78458. Looking to see if anyone has gone with this newer...
  4. 8

    Alpha One Gen One transom bolt torque question

    Hi again all, I have replaced gimbal housing and wanted to know if there is a spec for torque when tightening nuts and bolts. Thanks Rick
  5. 8

    Alpha 1 gen 1 bellows replacement order?

    Hi all, I am doing a bellows replacement on 89 sea ray 200 CC. Which side first to attach bellows? Gimbal or bell housing first? Thanks Rick
  6. 8

    Alpha one gen one shift cable replacement help needed

    I am replacing the shift cable on Alpha One Gen One drive. I have the gimbal assemble removed from the boat including the transom plate. There is a small allen set screw on the shift cable slide that I cannot remove. I have ordered the complete kit including the shift cable slide replacement...
  7. 8

    4.3L 1989 engine fuel pump has extra line

    Hi All, I am doing some engine work on a 1989 Sea Ray 200 cuddy with 4.3l 2bbl carb. Noticed fuel pump has line in/line out and extra hose that goes from pump and is sitting on intake manifold not connected to anything. Checked manuals and on line and cannot find anything about a 3rd hose on...
  8. 8

    89 searay alpha 1 gen 1 upgrade question

    I have 1989 200 cuddy with 4.3 v6. I have a steering issue and need to replace steering lever and pin. I was thinking of going from gen 1 to gen 2 gimbal and outer transom and wanted to know if transom hole pattern is same for both models. would I need both inside and outside transom plates...
  9. 8

    Steering lever replacement 89 200 cuddy

    Hi Members, I am working on restoration of a 1989 Sea Ray 200 Cuddy with 4.3 v6 and alpha 1 stern drive. I need to replace the steering lever. The bolt to tighten was broken and seems to have worn the lever. Need to replace lever and pin. Will I need to pull engine to fix? Thanks all, Rick
Back
Top