Search results

2002 280 Sundancer. Last season I had small (annoying) drip coming from just above the steering lever that goes through transom. There are two locknuts and flat washer that bolt to transom just above the steering lever where I think water is coming from. I can see rust on steering lever. Is...

Does anyone know where to purchase the light bulb that is in the galley for the AC electric current bulb, the size is E14 110V 25W. The picture below is from the owners manual. Do I really have to go through a Sea Ray dealer for a light bulb? The base is the hard part, I believe it is a...

The cover on the Starboard side is separating from the fiberglass. Does anyone know how to repair it? I can't see where any screws are holding it on, just looks like caulk holding it on. It is the outside cover for the ventilation of the engine. Any help?

Can anyone advise or point me in the right direction? What legal rights I have and how to proceed? I had my 2002 280 Sundancer winterized at a marina who was supposedly a certified Mecruiser and Sea Ray dealer. I told them when I wanted to take it out of storage and to spring it. Winterized...

Any idea what is best way to get to it? Mercruiser 496 MAG Bravo single engine. 100gal tank. Fuel gage stuck on "E", I m chasing ground wire on sending unit. How do you get access to it? I am estimating under 50gal. fresh water tank or under aft cabin. Any ideas?

2002 280 Sundancer. Windless anchor will go up, but not down. I can use manual tool and lower it and up works fine. When I push down button I get click from solenoid and it won't go down. Solenoid problem or motor? Any ideas? Who installed it or how did they get it in, very small area to...

Starboard Switch Pad, turns on nav/anchor light, horn, music, depth, cockpit, arch lights etc etc. Sometimes I hit the switches everything works 10% of time. Other times I get nothing, have to toggle back and forth to finally get indvisual switch to work. Other times it will turn on, but I can...

I have a 2002 280 Sundancer. The digital depth gage on dash is not readable, some lines show some don't. Does anyone know where I get a replacement? I want to keep orginal style, really dont want new modern type, they just don;t blend in with orginal gages. Anyone know where I could find one?

I have a 2002 280 Sundancer. 498 Mercruiser Mag with Brovo III lower unit, single engine. Problem I can not get full RPM. Fire engine up, purr's like a kitten, no skip, no sputtering. Pull away from dock leaving marine low RPM, same purr, no skip, no sputter. Get out put throttle down goes up...