Search results

  1. J

    borg warner velvet drive housing warping

    Is there a problem with the 2001006 borg warner velvet transmission that required more metal in the housing to keep from warping and the new trans part is 3001006. Should the orginal 2001006 not be used? Ihave located a new 2001006 and looking to purchase it.
  2. J

    borg warner velvet transmission gears checking if cause shaft vibration

    borg warner velvet transmission bearings/gears checking if cause shaft vibration This is a continution of my search for shaft vibration on searay 420ac , see that thread. How can the output bearings/gears on the borg warner velvet transmission be checked without pulling transmission. Not sure...
  3. J

    how to check shaft is straight and true

    How to check long shaft is straight without removing shaft from boat?? Shaft is 1.75 inches by 10 feet or so."
  4. J

    how to check shaft sraight

    How to check long shaft is straight without removing shaft from boat. Shaft is 10 feet or so.
  5. J

    searay 420ac shaft whipping

    The shaft is whipping, shafts are straight, engine and flange have been aligned and prop and cutlass bearing appear ok. What else needs to be checked that can cause the whipping on these long shafts.
  6. J

    rerplace fresh water pump

    replace fresh water pump the installed fresh water pump uses genova compression fittings that are not available from most local stores. Need to replace one of the pumps, what would be a better fitting choice for the associated piping?
Back
Top