Search results

This was kind of touched on in another thread but didn't want to hijack the original question. I bought a 19 inch LED TV to use in our boat. I was looking at the power supply on it which plugs into a wall outlet (120v ac) then runs to a small box which converts it to 12vDC/3A, then to a 2.5mm...

I am getting close to needing my first 100 hour service done and need a couple of warranty issues taken care of which will require the boat to be out of the water. I have a trailer to haul it out and take it to MM about 80 miles away. I had a couple of ideas and looking for feedback on the best...

Being this is our first experience owning a cruiser and being slipped year around the question I have is.. Is it safe to block off the bilge vents on the side of the boat? I have a bilge heater and leave the cabin set a 55. I had one person tell me yes and one tell me no. I figured blocking...

I pulled the boat out for some fall wash, wax, and general inspection. When I was looking at everything, I noticed a lot of mineral build up on the drain plug and fitting, and intake for the generator and a/c. The build up was about a quarter of an inch thick. it could be removed by using a...

I have a question on how much water should be in the bilge on a 2007 260DA. The boat is wet slipped (freshwater) in a covered slip so it doesn't receive any deck run off. The boat was hauled out a few weeks ago to have some additional items installed and I ask them to check all the thru the hull...

Hello everyone. My wife and I live on the west end of Lake Texoma and expecting the delivery of our 2007 Sundancer 260 this Wednesday February 20th.:smt038 We will have it in a slip on the Big Mineral arm of the lake. This is our second Sea Ray which our previous one was a 2006 200 Select and...