Any ideas? It has new plugs and runs great if started cold or cool. I ran it this weekend for 22 hours straight after I finally got it re stated. It needs about 5 hours off to get it to start. If it is hot I get 2 "pops" and then 5 seconds of cranking and an OC code with raw fuel in the exhaust...
https://www.facebook.com/aquapaloozalive?fref=ts
:smt038 :smt038 :smt038 :smt038 :smt038 :smt038 :smt038 :smt038 :smt038 :smt038
Weather is going to be awesome.
Details for Saturday, July 19
Times of sun and clouds. Highs in the upper 80s and lows in the low 70s.
UV Index...
Any idea what could cause all three batteries to be down to 2.35-2.47 volts after 2 weeks being off in storage.
Is EMRG bildge pump hooked to both sides?
I am having trouble getting the AC pump to prime using the same setup I use to flush the Generator with no problems. Ideas? Does the AC pump need the impeller or whatever is in the pump changed? Works ok in the water. :huh:
FYI.
The new plastic raw water B3 housing this year is plastic instead of brass and has a replaceable wear plate. When you install it put silicone behind the wear plate to prevent an air embolism when you put the boat back in the water or flush on a trailer.
Major PITA if you or the service...
2006 290 Sundancer
Anyone ever find the stubbed out wires for ACC2?
Here is what I know. It would have been used at the factory if the option under water lights had been selected. It has a breaker on the aft EIM (ACC1, BTW has a breaker on the FWD EIM). I have searched the engine room wiring...
I have an intermittent problem with the display rolling horizontal lines and the screen goes to a tan/white color, completely unreadable. It has now done it on all sources of power. Any ideas? Power connection or an internal fault??????
Thanks.
What is the min required psi and flow rate for flushing a 5.0 MPI/Bravo III?
I am building a trailer brake flush system with a salt away holding tank in my truck bed and i might as well plumb it with a connection to flush the motors as well. I am trying to figure out how big the pump will need...
2006 290 DA 5.0 MPI's B3's
Last week while running, the Starboard engine started a 2 beep alarm every minute or so and would not idle but in gear and WOT ran fine. Easy fix (I think). Put it on the trailer and turned both batteries off. Replaced IAC next day. Then I went to run it and there is...