Search results

Port starter is dragging. They tried to replace today but said can't be done without raising engine. Anyone got experience with this model? Any tips/tricks?

So in the never ending saga of one thing leads to another. While replacing pump, found out seal was bad and water in the gear lube, when opening the top, bearing bad and case damaged. Lower unit doesn't look brand new by any means, and it was running in the same muddy grease, but it was...

Order new thermostat for starboard engine because whoever replace the engine put a 165 in it instead of the 142 it calls for. I ask when I ordered does it come with gasket. Answer was never seen one not. Well guess what........ So question is it ok to use rtv instead of gasket? If so what color?

I have 12.5 volts at fridge wires but if I hook them to the fridge drops to .5 volts trying to figure out if fridge or wiring any idea where the fridge wires are on the bilge side There not a separate breaker for it either in the cockpit or the breaker panel in the bilge

Sometimes we like to go slow, what's the trick to going faster than a fast idle and slower than planning? Once I get over 7 or 8 MPH it just feels like i am really making the boat work. Is it my imagination? I can keep it on plane using the tabs down to about 22-23 Mph. But that's faster than we...

So now that we have our boat at River's Edge we are ready to start exploring a little. I was think Morris Island might be a good first spot to check out. Me and the Admiral really just like to find a nice spot to sit out and relax and get in the water to cool off once and a while. Any place...

Under the sink in the head there is a 12 volt valve hooks into a T from cold freshwater line and runs to what looks like a macerator pump at the base of the stool. Of course it is bad. Have found anything at west marine, lawn sprinkler systems have smilar part for less than $10 but 24 volt...

My Port Engine runs fine when cruising, but around the dock or in a long no wake it usually dies after a minute or two. You can usually smell unburned gas at this point, and takes 20 seconds or so of cranking to get it to restart. Back in my day with Carbureted cars I would say that the carb was...

Not sure right name but the door into the cabin is bifold and then on the dash there are tracks that something slides over the opening. I have the slides on dash but none of the hardware or parts that cover the opening.

I am planning to add a windlass to our Sundancer. I have settled on a Good Windlass because they do not require it to be tied off, and the whole point of adding a windlass is because the wife doesn't like going forward to deal with the anchor. Got several questions for those of you who have...