Hello, I hope everyone had a better weekend on the water then I did, well, I really didn't make it to the water at all...
Friday afternoon I tried starting her up but she wouldn't turn over at all, it turned out to be the starter.
Now she turns over but will not start.
What would be some of...
Hello Everyone!!!
I live in Lakeland, FL which is about 30 minutes from Tampa and 45 minutes from Orlando. Does anyone know or recommend anybody in this area to get some reupholstery done on my boat??
Thanks in advance to all!!!
Frank
I finally got around to polishing the boat. She looks great but now the bottom paint is an eye sore. I purchased a stripper to take it off. I tried it on a 4"x4" section but it was extremely tedious and time consuming. I asked around and got a few suggestions such as reapply on top of the old...
Sorry for the confusion, it is not EFI, it has a 2 bbl carb.
The fuel filter was changed Friday afternoon. I asked a friend of mine and said it may be old gas, could this be?
I put this engine in alittle over a year ago. The mechanic that put the engine in did the heads before the engine went in. I also rebuilt the carb and rebuilt the lower unit.
No it doesn't miss on idle. I did notice I am missing the exhaust bellow.
I finally put the boat in the water this weekend!!! It was great except for a few instances, here's what happened.
After leaving the channel, which is a no wake zone and takes about 10 minutes, I bumped up the throttle just alittle to make sure everything was okay. Then I brought her up to about...
Guys,
Thanks for your replies. I installed it already and works like a charm. You guys and this forum has saved me once again.
Thanks!!!
:smt038:smt038
Ok, I checked the parts manual and it told me part# 807653T (65amps) is the correct alternator for my engine. Now that I go to replace the old one, the old one says part# 807652 with is a 55 amp alternator. Would it be okay to use the 65 amp instead of the 55 amp?? I have no idea!!!
Thanks...
Skolbe, thanks for the reply.
I have 2 pulleys that look like pucks. One is by the power steering bracket (above the alternator) and the second one is to the left (I believe it is on the Idler bracket, per the online parts diagram). I'm assuming you are talking about the one on the idler bracket?
Hey Guys! Hope everyone is doing well.
I have a 2000 Sea Ray 210 Signature w/ a 5.0L EFI Mercruiser. I was wondering if someone would tell me where and how do I tighten the serpentine belt? Thanks!
Hello All,
I have a 2000 Sea Ray 210 Signature with an Alpha drive. I usually keep it in the water but last week I took it out for some repairs. While looking it over I noticed the exhaust bellow was missing. The two questions I have are:
1.) Is running the boat without the exhaust bellow bad...
Hello to everyone. I am new to this site and this my first posted. Would someone help me find where the access is for my fuel sender? I have a 2000 DSea Ray Signature 210.
Thanks...