boatrboy, do you have any close up pictures of this setup? Didn't see any in the thread you sent.
I am curious as to what did you used for a rail mount, hardware etc.?
Thanks
Thanks Ron, sounds like I'll have to go with the 16 x 15 as a replacement.
Given your performance it should work well, may turn a little more RPM but would rather that than be under powered.
Thanks again
skuza, Did you ever find replacement covers? I too am looking for some for my 1999 310 (NAV V398 GPS/Loran, RAY 430 Loud Hailer).
All I can locate is the VHF from Raymarine direct for $20.
Thanks
Greetings, I am using the weaver snap davit system to hold a 9 foot PVC dinghy on the swim platform.
I saw some where a stand off brackets / pole that screw into the oar thread on the dink and clamped to the stern hand railing. This appeared to be a great setup.
Has anyone seen this...
RonF, do you know what size props were on the boat before you replaced them and what performance (RPM Knots) you were experiancing?
I recently purchased a 1999 310, new engines (per recall, less than 200 hrs) and the props are Dimex 16 x 15.5. The Starboard prop is bronz and had some...
Greetings all, I have the same problem and after investigation the check valve on the inlet of the atwood water heater is not working.
When I disconected the inlet line from the brass fitting that screws into the tank, there was the remains of a small plastic piece which looked to hold a...