Search results

We are looking at relocating the boat for next season, has any one had any dealings with Ingram Bay Marina (just of Great Wicomico river) , it looks to be a very nice/clean facility. Thanks!

Thanks! I figured someone else would have had a similar problem.

One of the 110 lights on my overhead has gone out. There is a small capacitor that twists into the housing, I know it is bad because i swapped it to the other side and it worked. Any idea where to get one? No numbers on it at all....... Thanks!

I think we are going to head over and watch the show by water, we are just around the corner at Coan River. Might spend the night on the hook......

Todd, They are made by ShadowCaster, super nice people, plus there are alot of different color options. I bought mine at the Annapolis Boat show, I am not sure what they sell for normally. I can give a contact if your interested.

They have done pretty good, I do have to clean them off about every two weeks just to keep the growth off of them. They are super bright, really brings up the fish. Haven't been bothered about them yet............

Finally took some better pictures of my underwater lights

Thanks! Going to look now......

Can anyone tell me where the junction for the tv wire is. I'm looking for the end of the wire from the antenna, I have followed it thru the arch and down to the cockpit fridge are but lose it from there...........thanks!

I went with Shadow Caster LEDS, met the guys at the boat show last year. Nice guys with a great product. I had looked at a couple of the others but you can get these in different colors. Thanks, Bill

Finally able to splash our "new" boat, installed new underwater lights over the winter.....along with a bunch of other upgrades.

Thanks, yea the old ones were very faded. Pulling the dash panels was really pretty easy, there were connectors on all the panels. As far as switching over the gauges and rocker switches it was just time consuming. I had marked each wire and gauge with wire tape (has numbers printed on it) so I...

David, I just bought this boat at the end of the summer, and someone had cut an opening for the old chartplotter/radar so I had to fabricate a panel to cover the old hole and mount the Garmin. I picked the Sea Ray emblem up at the local dealer. Thanks, Bill

Thanks, that was the worst looking part of the boat , they were so faded and cracked. Scott Cambra did them - Vector Imaging.

Finally able to install the new dash panels and GPS. What a difference...

I was too, the biggest problems I had were getting to the port side tube, and working upside down, I am 6'5" and didnt think I would ever get to the port side clamps. Just take your time, once I started and got everything apart it really wasnt too bad. Oh by he way, make sure to use dish...

Just finished installing new shaft seals on our 330DA this weekend, had researched the older forums before I tackled it. It is a V drive and wasnt sure if the engines had to be pulled, but after reading the older posts and working upside down its finally done. Those older posts helped out...

I like the stereo/sub upgrade. I have just begun to upgrade my stereo and electronics.....gonna have to go with a sub after seeing that. Also wanted to thank everyone for ideas and contacts they have posted, I contacted Scott Cambra about gauge and switch panel replacements. Wish him well, he's...

Thanks everbody for your input, I will check out thr link as well.

Looking for some advice on props, I have pulled the props on my 330, it has twin 454''s with carbs and V drives. Both props are in need of reconditioning, I was curious if anyone is running Michigan Wheel 4 blades? Has it helped with the fuel milage/cruising speed? I have heard that the low end...