Pump was changed as it was leaking at the shaft, replaced with Mercruiser part. New sensor is aftermarket, sensor on starboard pump is original. Yes I'm looking at H2O and not oil pressure. What should pressure be reading? Screen reads "OK" at PSI that I'm getting.
A few weeks back I started getting an alarm at the helm, checked the Smartcraft screen and it called out low pressure on my port sea water pump. Changed out the sensor and two weeks later I'm getting the same alarm. I checked the pump pressure on the screen and it reads 37.5 PSI at Idle and 45...
Apparently the gasket sealing the upper and lower halves of my open array failed allowing rain water to enter causing massive corrosion. I've owned the boat since 09 and have never had the unit opened so assuming it was bad for a long time. As I'm not ready to upgrade looking for open array from...
Latest Result: I checked the voltage and had 12 volts at the slave solenoid, however I did notice that the wiring diagram which is for an out-drive not a V-Drive shows a separate ground from the slave to the engine block. The V-Drive does not have that wire as the solenoid mounting plate is...
No joy update, I swapped the port & starboard neutral safety switches with no change and also removed, cleaned and lubed the 4 cables at the engine ground terminal with the same result.