Last chance for a CSR member to get a great deal
Boat will be sold and sent to Florida
Look in Classified sections for details
380searayforsale@gmail.com
I want to change out the very noisy motor that is located behind the microwave.
The current motor is made by Mayfair.
I saw a post a while ago but I cant find it now
Thanks
2003 380 sundancer
2003 380 Sundancer 8.1 Gasser ZF Trannies.
This weekend noticed the starboard tranny did not "clunk" (positively engage) into gear when changing to reverse and when back at dock, I observed that the tranny would engage slowly after a couple of seconds and work fine thereafter, no slipping...
I have a 2003 380 Dancer with 8.1 gas engines.
On the prot engine, when at idle and the trannny is in gear, I get a clunk clunk clunk. and the engine starts jumping around. Does not do it at idle in neutral or when in gear above 900 RPM.
Mechainic thinks it is a misfire. I don't think...
I need to find a repalacement Raymarine RN300 GPS. Raymarine doesn't have replacement parts. Anybody know of a source or have an old one collecting dust. A new similar size gps/chartplotter has completely diffferent seatalk and NMEA plugs. I don't need it but I don't want a dead one on my...
Will the dashboard switch for existing oem horn work on a dual trumpet air horn? Will I need a relay or is the switch rated for the draw on the air horn?
Question for the electrcal gurus.
I have a vetus 75 12volt with a 200 amp hr 4D AGM Deka battery on a smart charger.
I have 12.8 volts before and after using the thruster. My question is when the thruster is in operation what voltage should I get at the motor. Under load should the...
When testing boat systems, Bow thruster would not run for more than 10 seconds and then slow down and then stop and then be fine 2 minutes later and repeat symptoms. Thought is was the battery but voltage stayed at 12.75 before and after. Had someone run the thruster and I went below and saw...
When I'm at idle on the port engine (650 rpm) and have starboard engine slightly higher (800 rpm) the port engine chatters as if it is misfiring. This only happens when the port tranny is engaged and stops if I put the port tranny in neutral or increase rpms.
Mechanic changed a computer idle...
When I'm at idle on the port engine (650 rpm) and have starboard engine slightly higher (800 rpm) the port engine chatters as if it is misfiring. This only happens when the port tranny is engaged and stops if I put the port tranny in neutral or increase rpms.
Mechanic changed a computer idle...