It seems to have been a bad sensor. My port side trim sensor started fizzling out a year ago and eventually stopped working. (I read that this was an issue for many people, so decided to turn my attention to that particular sensor.) When I unplugged the sensor the low voltage fault code went...
Thanks for your guidance and feedback by the way. I used one of those load testers with the coils that heat up and glow. They were not disconnected. That makes a difference I take it? I will try that. Will also test the charging system voltage test.
Thanks for your guidance and feedback by the way. I used one of those load testers with the coils that heat up and glow. They were not disconnected. That makes a difference I take it? I will try that. Will also test the charging system voltage test.
Hello: can anyone tell me where the knock sensor is located on a Merc 496 MAG (2008 330 Sundancer). I keep getting knock sensor failure warnings on the smartcraft (when I usually get over 3500 RPMs) and they are now accompanied by low voltage sensor warnings (that pop on and off after I turn the...
I have both types at the house- a 30 amp that you will find in marinas and the more typical outdoor household version. Working with a reputable certified marine electrician to hopefully resolve what sounds like a leak.
On the breaker panel (see pic) I have four main breakers: generator, shore 1, transfer, and shore 2. The shore 2 button doesn’t work - meaning it doesn’t click into place when I toggle it. My battery charger and air conditioning are on shore 2. Until late last year I was able to supposedly...
Hi all. For the tracks that run along the outside of the radar arch with the slide in zippers that zip to the aft curtain, where would you buy a replacement zipper element (not the track, which is fine)? Boat is 2008 330. Thanks
Ok...thanks a lot for the reply. This makes a lot of sense based on everything I’ve been reading. Will give it a whirl by week’s end and let you know where I landed. Thanks again for the quick reply.
Hi. Have been a follower of this forum for many years; first time asking a question. I was trying to install a new led navigation light to a 2008 sea ray 330 when I snapped one of the wires coming from the hull of the boat to supply electricity to the light. When I went to look at the wiring...