Mine does not have a stove and only a single engine compartment. She didn’t run when I bought her but I put in a new starter and cleaned the carburator new plugs, wires cap and rotor and she turned right over and ran smooth. Gel coat is good, nothing a good wet sanding and detailing can’t fix...
So here’s the update. I’m going with air locked. Today I was preparing to take her out and upon initial start up low gear oil alarm sounds. Reservoir very low. I filled it and no more noise. So I assume the air worked it’s way out and the reserve oil filled the void.
Pretty sure alignment is good. All the rattle comes from the upper unit. I Removed the top cover to look inside and it looks good no metal filings or chips gears looks solid
I have the alignment tool and it went in perfectly and I was able to turn it with two fingers. I also filled the unit from the bottom with the top screw removed till the oil started to come out.
Hello. So 2019, has not been good. I threw a rod in my 1997 5.7 mercrusier. Bought a brand new 5.7 GM Longblock marine engine and swapped it myself. Runs and sounds great except I notice a loud rattle in the upper unit at like 1500-2000 rpm. Any suggestions?
This past weekend I had what I considered a text book stern in anchoring at the beach. Approx 50’ line of front anchor with2 1/2’ water at stern platform. I walked my rear anchor to the shore line unloaded the boat sat in my beach chair.
Then... the tide went out! Thank you Boat Us! My new...