Fellow Captains,
Recently had a repower on our starboard engine. It was time and it had low compression on two cylinders. Genuinely very happy with it now - couldn't ask for better. However, I'm a tinkering type and have some questions.
New engine has been going through break-in as...
I feel for you. I went through something similar. Still going through it. Good compression, had it hauled out, transported, drove to new slip - then blew oil everywhere and I have two cylinders at 40psi.
hang in there.
Ahoy!
If you’ve seen some of my other posts you’re aware that I’ve been fighting a bum 454 in my 95 330DA.
I’m afraid there’s no saving it and I’m currently sourcing a take out. My questions are-
1- with my boat being v-drive, is there any difference between a v drive and stern drive 454...
Hey Guys!
Interested in upgrading my electronics. We're on the Ohio River - no need for anything to bananas or offshore capable. But I have an opportunity to upgrade our Chart plotter and add a fish finder, so I'm going to take it :)
Only real stipulation - I want an In-hull transducer...
I’m pretty sure it’s not the carb.
First thing I did was use a mechanical pump to get some fuel moving out of the line. Attached to carb, tried starting with starting fluid - it started for just a moment and quickly died once starting fluid burned off. Not getting fuel.
replaced fuel filter...
this is helpful. Going to grab a fuel pump tomorrow and possibly a new raw water pump. Planning to see if the new fuel pump moves significantly different than my one in my hand currently. If that’s not it… probably raw water pump. Yay.